Before mixing, use a small trowel to clean the mixing material from the barrel wall, and then pour clean water into the mixing barrel. Slowly add gypsum powder while stirring, and use an electric mixer to stir until it is even and free of lumps. Let it stand for about 2 minutes, and then stir for another 30 seconds before use. The amount of material to be mixed each time should be based on the required amount of leveling area, and should not be too much. It is necessary to mix and use frequently; The mixed slurry should be used up before the initial setting, and the slurry that has already set should not be mixed with water again.

批刮找平

Batch scraping and leveling

用灰板將配制好的漿料批刮至墻面，然后用鋁合金刮尺刮平，每次施工厚度不大于15mm，總厚度大于15mm，應該分批找平；首道批刮時，可先在基層上進行薄批，然后連續上料，這樣有利于空氣排出，提高與基層的粘結力；若批刮后表面局部出現泛白脫粉現象，可用毛刷蘸水，對泛白表面進行補水處理，水量以不滴落及不破壞砂漿層為宜，待完全干燥后進行下道工序施工。

Scrape the prepared slurry batch onto the wall using a gray board, and then use an aluminum alloy scraper to level it. The thickness of each construction should not exceed 15mm, and the total thickness should be leveled in batches if it exceeds 15mm; When the first batch is scraped, a thin batch can be applied to the base layer first, and then the material can be continuously loaded, which is beneficial for air discharge and improves the adhesion with the base layer; If there is local whitening and powder peeling on the surface after batch scraping, a brush can be dipped in water to replenish the whitening surface. The water amount should not drip or damage the mortar layer, and the next process of construction should be carried out after it is completely dry.

03

03

1、本品按照參考比例加清水即可使用，禁止與其他石膏粉混合使用!

1. This product can be used by adding water according to the reference ratio. It is prohibited to mix with other gypsum powder!

2、施工溫度建議在5-35℃，空氣相對濕度<85%條件下施工，溫度和濕度的變化對可用時間及干燥速度都有影響。遇夏天高溫天氣，磚墻、混凝土墻、頂棚找平前，噴灑1-2遍水進行潤濕，表面無水珠流淌即可進行施工。遇大風天氣施工，建議關閉門窗，避免因空氣流通過快導致表面迅速失水影響強度。

2. The construction temperature is recommended to be between 5 and 35 ℃, and the relative humidity of the air is less than 85%. The changes in temperature and humidity have an impact on the available time and drying speed. In hot summer weather, before leveling brick walls, concrete walls, and ceilings, spray 1-2 times of water to moisten them. Construction can proceed without any water droplets flowing on the surface. When constructing in windy weather, it is recommended to close doors and windows to avoid rapid surface water loss and strength impact due to rapid air flow.

3、攪拌請使用干凈的桶和工具，切忌將已干結的漿體拌水后再用。

3. Please use a clean bucket and tools for mixing, and do not mix the dried slurry with water before reuse.

以上就是所講解的三步搞定輕質抹灰石膏的施工事項了，希望能夠幫助到您，更多事項就來我們網站http://www.daquanq.com.cn咨詢！

The above are the three steps explained to complete the construction of lightweight plastering gypsum. We hope it can help you. For more information, please visit our website http://www.daquanq.com.cn consulting service